Start of abstract submission May 15, 2023
Abstract submission deadline June 17, 2023
June 24, 2023
Notification of acceptance June 20, 2023
June 20, 2023 ~ June 28, 2023
Start of registration May 15, 2023
Early registration deadline June 24, 2023

Keynote Speakers

Prof. L. Jay Guo
Univ. of Michigan, U.S.A

Scalable and additive nanomanufacturing and applications

Dr. Helmut Schift
Paul Scherrer Institut (PSI), Switzerland

Nanoimprint more than lithography


Prof. David R. Myers
Emory University & Georgia Tech, USA

Translating Biomedical Microsystems with Non-traditional Fabrication Approaches

Prof. Meng Lu
Iowa State University, USA

Leveraging scalable nanomanufacturing for photonic and diagnostic applications

Prof. Aaron T. Ohta
University of Hawaii, USA

Liquid Metals for Reconfigurable Wireless Communication Systems

Prof. Hiroaki Onoe
Keio University, Japan

Fully degradable wireless microsensors for biological and environmental monitoring

Prof. Ming-Tsang Lee
National Tsing Hua University, Taiwan, R.O.C.

Opto-thermal-fluid coupling multiphase transport in laser assisted micro/nanoscale additive green manufacturing processes

Dr. Jason J. Gorman
National Institute of Standards and Technology, USA

Integrated cavity optomechanical systems for sensing and computing

Prof. Heeyeop혻Chae
Sungkyunkwan Univ., Korea

Plasma-Enhanced Atomic Layer Etching of Metals and Dielectric Materials for Semiconductor Device Fabrication

Prof. WonHyoung Ryu
Yonsei University, Korea

3D Printed Photosynthetic Electrodes for BioSolar Energy Harvesting

Prof. Seung Hwan Ko
Seoul National University, Korea

Nanomaterial based wearable electronics development

Prof. Young-Jin Kim
KAIST, Korea

Direct Laser Writing of Laser-Induced-Graphene (LIG) Electronics

Prof. Wonjoon Choi
Korea University혻, Korea

Ultrafast extreme thermal-chemical-electrical wave for fabricating multi-material/interface structures for energy storage and conversion devices

Prof. Chulmin Joo
Yonsei University, Korea

Computational polarization microscopy for tomographic birefringence imaging

Prof. Hoon Eui Jeong
Ulsan National Institute of Science and Technology, Korea

Bottom-up manufacturing of responsive artificial cilia

Dr. Yeong-Eun Yoo
Korea Institute of Machinery and Materials, Korea

Injection Molding and Packaging of Plastic Micro-Fluidic Chips

Prof. Hongyun So
Hanyang University, Korea

3D-printing-assisted manufacturing of functional sensors, actuators, and surfaces for various engineering applications

Organizers :
Sponsors :